dragon center 2.0 not working windows 10

I can even control the colors from my MSI motherboard software. In my case, I had downloaded the wrong version of the driver software. It took me a while to figure it out, but once I had the above setup, the software worked. Each driver version is only looking for the model of cooler it is tailored for, so make sure that in your case, you download and run the WRAITH PRISM software. For instance, you cannot use Wraith Prism software with a Wraith Max cooler. The software you use should match the model of Wraith cooler you have.The cooler can ONLY be connected to a standard USB 2.0 header. FYI, I'm guessing the AMD USB HEADER on your motherboard is proprietary and is not compatible with this cooler.In this state, the software will not be able to communicate with the cooler. If the RGB wire is connected, the controller will default to using the RGB control and USB control will be turned off. After the update of the Dragon Center, even if I put the MSI Center or a previous version of the Dragon Center, they no longer work because the update 'burned' the motherboard RGB. I followed MSI's advice, formatted the PC, flashed the BIOS, but they still didn't work anymore. For color control, however, ONLY the USB wire should be connected to a USB 2.0 header. 2.0.109.0 and all the led RGB on the mobo stopped working. Of course, for fan control, the fan header should always be connected to the CPU fan control header on the motherboard.Im lost.There are two conditions that must be met in order for the Wraith software to work: When none of this software is installed pc is running amazing. My gpu shuts off and which causes the blue screen crash. Maybe just the rgb software is causing my crashes? Im running a gigabyte 3070 gaming oc. I also notice when i install the aorus engine and then try to install rgb fusion 2.0 it also crashes with the same error. Im running a msi z490 gaming carbon wifi motherboard. I clean install dragon center everytime and make sure any traces are gone when i uninstall. Ive taken my pc apart and rebuilt it just to make sure everything is seated right. Ive tried everything from defaulting bios to removing all rgb software from other programs to wiping my pc all together and downloading drivers all over again to even flashing bios. After restarting the laptop, the processor name will restore itself. Change the processor name in the registry to the 10th generation of Intel processors (for example, i7-10870H). Installation Instructions: - Download Dragon Center UWP ( link ). It always ends up crashing my pc with a whea hardware fail as soon as i run it as admin. MSI Dragon Center UWP support for 8th and 9th generation.

Most posts about it are old but I cant seem to get it to work. I know i see a lot of posts about dragon center causing crashes or not working.

Dragon center 2.0 not working windows 10